Hand Held Vacuum And Pressure Pump Tester Tool Car Brake Bleeding Kit
3 Gauges Hydraulic Nitrogen Accumulator Charging System Pressure Gauge Test Kit. Petrol Engine Compression Leakage Detector Cylinder Gauge Tester Adapter Kit.
Hand Held Vacuum And Pressure Pump Tester Tool Car Brake Bleeding Kit. 22pcs Brake Bleeder Tester Tool Kit Vacuum Pump Motorcycle Bleeding Hand Pump.
Universally applicable for almost all cars. Suitable for checking pressure and vacuum systems such as: Checking charging pressure, vacuum solenoid valves, tank ventilation, MAP sensors, etc. Thanks to extensive accessories (accessory caps and inserts) can also be used as brake vents. Print display range: +0 to +3 bar. Vacuum display range: -0 to -0.8 bar.
63.5 mm pressure/ vacuum manometer. Long hose: outer diameter: 9.5mm, inner diameter: 6mm, length: 60cm including 2 pieces 120 ml vent container Hoses each with a length of 90, 75, 60 mm and 2 pieces 550 mm Adapter 90° Vent nipple 2 pieces 7.5 mm, 1 piece 6 mm inner diameter Adapter cone 8 pieces in different diameters and lengths Adapter 1 piece from 7 to 5 mm diameter Adapter 1 piece diameter 35 mm 1x Plastic storage case.
1xBrake vent pressure pump vacuum pump brake vent pressure tester hand car. Product type: Car brake vent Material: plastic, metal Installation: universal for most cars. Make sure that the storage tank from the main brake cylinder is full and the container is open.
Connect the 50 mm long plastic hose to the lid of the vent container and place the lid on the vent container. The short hose must now be in the container. Connect the other 50 mm long hose. Connect one end of the long hose to the vent container and the other end with a matching "pipe" for the brake caliper vent nipple. Generally, venting is in the following order. Start with the wheel cylinder located the farthest away from the main brake cylinder, then the one at 2 farthest away, etc. The order is usually: rear right, back left, front right and last front left. Place the vent pipe on the vent nipple of the wheel brake cylinder or brake caliper. Pump 10-15 times until a vacuum is created. Open the vent nipple until the brake fluid flows through the hose without bubbles. NOTE: Operation C and D may repeat several times. Check the brake fluid level in the reservoir before venting the next wheel brake cylinder or caliper. Important: Finally check the brake fluid level, fill it up if necessary.It is an aftermarket tool, it serves as a replacement of the original tool. We recommend a professional installation. Will this fit my car? When will my order be dispatched? Can I amend my order?
What do I do if I have not received my order? What do I do if my product is faulty? It will speed up the process if you could provide us some pictures or video to illustrate the issue details. Other items you might also like. 12pcs Oil Pressure Tester Measuring Instrument Oil Pressure Meter Set Tools Car.
Every message will be replied within 12 hours on 7x24 hours. 7x24 hours, always here for you.